Standard Decoilers 
For use pre-painted galvanized steel coil sheet up to 5 tons in weight. The coil holder is supplied with two supporting wood and expanding mandrels.
Roll Forming system  
This system is equipped with decoiler, pre-slitter and controller.
Pre-cutting system ( for cutting corrugated sheet)
When the sheet meets the set length, it will cut automatically. The tolerance is ±5mm when the length more than 3000mm.
Coil Guiding equipment
When the coil sheet come the laminator, the guiding system ensures the sheet to the correct position.
Pre-heating system
Before glue scraping, the coil sheet will be heated in this system.
Guiding roller core
When the EPS fed to the machine, the guiding roller will guide the EPS to the laminating cabinet, the roller core will go the cabinet too. This makes the EPS closer to the top and lower coil sheet, thus make the finished panel more solid.
Glue Providing
There are 4 drum stand, with proportion at 60:40 (the glue is provided by the buyer, and the quality shall be meet the speed at 3-4 meters per minute). The glue will scraping at 4 directions, this guarantees the glue can be supplied at different speed.
This part is operated separately.
Glue Filling Pad
The pad is in to-and-fro movement, there are air cushions on the concrete pad.
Heater
To open the heating pipe or not and how many pipes to open, is depend on the temperature and the solidify time of glue. The heater is to heat the top and lower coil sheet at appropriate temperature in laminating